«PACS-classification: 84.60.-h, 89.30.-g, 98.62.En, 12.20.-m, 12.20.Ds, 12.20.Fv Summary of a Scientfic Work by Claus Wilhelm Turtur Germany, ...»
At atmospheric pressure (i.e. without vacuum) there is a torque bringing the capacitor plate into rotation until finally the torque of the torsion wire stops the rotation. Switching the electrostatic high voltage on and off in appropriate moments makes the capacitor plate fulfil a pendulum movement of rotation, but unfortunately the video (done as a part of the record of the experimental documentation) never displays one full turn of rotation or more than one turn of rotation. Furthermore [Nau 07] states that the torque causing the rotation of the capacitor plate directly increases with the high voltage and also this torque completely disappears at a voltage of zero.
At a vacuum pressure of 1.72 106 Torr, the same type of pendulum movement of rotation as observed under air can be seen, but the torque is much smaller than under atmospheric pressure. According to the knowledge our equation (1.68) this is not surprising.
Regrettably the NASA-work did not display the continuous rotation of the capacitor plate over several revolutions, and furthermore there is a lack of quantitative measurements of the electrical power and the produced machine power, as it would be necessary to verify the interaction of the capacitor plate with the inner structure of the vacuum, respectively to verify the conversion of vacuum-energy. Nevertheless the NASA-work confirms the results shown in the work presented here.
90 5. Outlook to the future
• Arkadii A. Popov Popov derived theoretically (considering gravitation) self-consistent solutions of Einstein’s field equations, that vacuum-fluctuations can create Lorentz’ian wormholes. Therefore he took interactions between vacuum-fluctuations and vacuum-polarization on the one hand and the curvature of spacetime on the other hand into account, which is the well-known gravitation [Pop 00], [Pop 05]. In a theoretical work [Liu 93] demonstrates, vacuumfluctuations can create Lorentz’ian wormholes.
On the basis of the awareness that even gravitation interacts with vacuum-fluctuations it is not surprising any further, that electrostatic and magnetostatic fields do the same (as used as a basis for the possibility to convert energy from the mere space of the vacuum as presented here).
• Energiekonverter nach Hans Coler A literature-research about „zero-point energy“ and „free energy“ and all types of energysource unknown up to now brings knowledge about many many further explorative work.
But the quality of these references are clear in all cases. The most easy way to treat this uncertainty would be to ignore all these references. But it is clear (at least since Nikla Tesla), that we would for sure ignore a lot of feasible knowledge if we would do so. At least we would lose the information about many free-energy converters which are working properly.
This is the attitude of most of my scientific colleagues, but they ignore visible phenomena of physics, just telling that they are away from their area of specialisation. Unfortunately, these phenomena are important for a clean energy-supply of mankind.
As an example for a layman’s exploration (I use “layman” as a synonym for “non-scientist”) is the work by Hans Coler. He was not trained to use the official terminology of science and also not the usual way of documentation. The situation reminds in some way to the discovery of the earth of geography in the 16th and 17th century. If geographers found new land (in analogy to our search for unknown energy-sources), they communicated with aborigines, and what they heard was far away from scientific terminology. But the scientists followed the traces they received until they finally got valuable cognition. It would be desirable that also modern physicists turn their minds to this modus operandi in order to find new unknown energy-sources, and to understand how to use them without polluting our environment.
As an example for such a layman’s work, we want to turn our attention towards the exploration of Hans Coler, because today there is report by intelligence service, which was made in the second world war, and which was indexed for several decades of years, but which is published in internet today [Hur 40]. Based on this report we find also some information in [Nie 83] and [Mie 84] nowadays. What we know is, that Hans Coler (and his coworker Mr. von Unruh) build two types of convertes, beginning in 1923, which they called „Stromerzeuger“ and „Magnetstromapparat“. Both engines have an efficiency factor of more than 100% (compared to classical energy-conversion). The „Stromerzeuger“ need some input-power, whereas the „Magnetstromapparat“ work completely wothout any energysupply. Coler brought his engines to the Universities of Berlin München, Trondheim and Kopenhagen, where they have been analyzed carefully. All the tests came to the result, that
5.3. Investigations by others 91 Coler’s engines are really bringing more output-power than they as input. These are serious confirmations of the conversion of free-energy from some energy-sources unknown up to now, but nobody understood the functioning principle up to now. Coler’s terminology was not understood by scientists, and so it is useless to try to repeat his explanation here. Because the realy observations were not understandable for all professionals and experts, they ignored the Coler-device completely. This is understandable, because experts do not like to speak about things which they do not comprehend. Unfortunately, the scientific community forgot about the Coler device completely. Thus the most authentic report existing today is [Hur 40] as mentioned above. But when I tried to reproduce the “Magnetstromapparat“, I was surprised, that the [Hur 40]-report has very small explanatory power. I thought, a national secret service should have educated staff to write documentations properly and understandable, but I found that this is not the case with the report about Hans Colers devices. Clear in any case is, that Coler began with few Watts of power, but during the years he learned to optimize his developments in way, that he could gain even several kiloWalls later.
Although the educated scientific community does not care about Coler’s exploration any further, there are some privat experimentators, who tried to rebuild Coler’s devices. Besides [Hur 40] there is a description of the Coler-devices in [Wik 09] (not explaning the functioning principle in modern terminology). A trial of reproduction of the “Magnetstromapparat” was made by George Hathaway in 1981 and presented at the Canadian „First International Symposium on Non-Conventional Energy Technology“, giving a voltage of about 50 mV. Further hints to other reproductions can be found at [Geo 10].
Because of this uncertainty, I tried to reproduce the Coler “Magnetstromapparat” (see Fig.33).
After an extensive process of adjustmend, which was surprisingly not according to explanations of [Hur 40], a machine power of approx. 25 milliWatt could be gained reproducible.
Also not in accordance with Coler’s original was the fact, that an output was an alternating current (AC), because Coler spoke about direct current (DC) power. By Fourier-analysis we found a very wide band of frequencies within the output-signal, but the local radio transmitters could be found with a strong contribution to the Fourier-spectrum. Thus it is not clear, how much energy is coming simply out of classical radio-signal. Not typical for complete energy supply by radio-signal is the fact, that moving and turning the “Magnetstromapparat” did not alter the output-power significantly, as it would be typical for 92 5. Outlook to the future a radio-antenna. On the other hand, it was possible to find a shielded room, in which the Magnetstromapparat did not give any serious signal at all. But it would be imaginable, that the shielded room also shields the zero-point oscillations of the quantum-vacuum [Lie 10].
For the results did not meet the results of Coler’s original setup, a final analysis of all details was not executed. On this background, I can not answer the question about the functioning principle of the Coler-setup now. I cancelled my analysis of the Coler-converter, after I got a confirmation of the ambiguity from a colleague, who also tried to reproduce the Colerconverter. He additionally explained me his findings, that our guidline in [Hur 40] is incomeplete. It is known, that intelligence service did not publish the report completely. This also explains the lack of informative value in the publication by [Hur 40]. Obviously they had had trained and educated staff to make the report, but not the complete report is free from being indexed still today.
Thus the resumée is that Coler’s findings are still explosive enough 90 years after discovery, that they are still partially indexed nowadays. This emphasizes the veritableness of his work and the importance to reproduce it in an appropriate way, filling up the missing parts in the available report. Therefore it looks worthwhile to understand the theory behind the device – this seems to be the only way to filling up the missing knowledge.
• Further Work There are many investigations and inventions regarding “some sources of energy still unknown”. We do not want to discuss those many methods and machines in the same detailed manner as the Coler-apparatus, because of the author of the report presented here did not try to analyze them personally. Thus we will speak exemplarily about several such convert of unknown energy, which are mostly mentioned in a book by Klaus Jebens [Jeb 06]. More details and references can be found in this book, together with information about the personal life of the inventors of such machines. Those who are not familiar with “free energy” might be surprised about the way how the inventions influenced the curriculum vitae of the inventors. It can be recognized that there are wonderful sources of energy, which inexhaustible and free from environmental pollution, and which might be utilized since centuries - but in reality they are not used at all. In reality they are unknown to the largest part of general public. But this is not the problem of science, but rather a problem of policy, and thus it will not be topic of the report here. Let us now turn our attention towards convergence
of unknown free energy:
Up to now I wrote about nearly a full century of investigation regarding the utilization of free energy, but this is only due to a restriction to our modern ages, in which we have rules like “energy conservation” and the “laws of thermodynamics”. Even before mankind found of these principles of nature (within the history of science), there have been attempts to develop mechanisms or machines which are capable to do permanent movement without a visible source of energy. A very old example for such a machine is the magnetic motor by Peter Peregrinus, documented in the year 1269 [Per 69]. For he did not know about energyconservation, it was not the peculiarity for Peter Peregrinus, to build and to see a machine running without energy-input. His devices contained a flywheel which was kept in rotation by the force of permanent magnets. Even if this was not spectacular for Peter Peregrinus, it
5.3. Investigations by others 93 should be spectacular for us today. Nevertheless, a reproduction of the old machine, followed by an impressive demonstrations to the public in the second half of the 20th century, was not regarded as very spectacular and was forgotten rather soon. This fate is not very untypical for inventions regarding the utilization of free energy.