«Safety Data Sheet Copyright,2015,3M Company. All rights reserved. Copying and/or downloading of this information for the purpose of properly ...»
3M(TM) Electronic Equipment Wipes #CL610 and 3M(TM) Notebook Screen Cleaning Wipes #CL630 01/22/15
Safety Data Sheet
All rights reserved. Copying and/or downloading of this information for the purpose of properly utilizing 3M products is
allowed provided that: (1) the information is copied in full with no changes unless prior written agreement is obtained from
3M, and (2) neither the copy nor the original is resold or otherwise distributed with the intention of earning a profit thereon.
Document Group: Version Number:
Issue Date: Supercedes Date:
SECTION 1: Identification
1.1. Product identifier 3M(TM) Electronic Equipment Wipes #CL610 and 3M(TM) Notebook Screen Cleaning Wipes #CL630 Product Identification Numbers 70-0051-5278-3, 70-0051-5279-1, 70-0712-0612-5, 70-0713-5718-3
1.2. Recommended use and restrictions on use Recommended use Office cleaner, Premoistened wipes for cleaning computer equipment
1.3. Supplier’s details 3M
MANUFACTURER:Stationery and Office Supplies Division
3M Center, St. Paul, MN 55144-1000, USA
1-888-3M HELPS (1-888-364-3577)
1.4. Emergency telephone number 1-800-364-3577 or (651) 737-6501 (24 hours) SECTION 2: Hazard identification
2.1. Hazard classification Flammable Liquid: Category 3.
Serious Eye Damage/Irritation: Category 2A.
2.2. Label elements Signal word Warning Symbols Flame | Exclamation mark | Pictograms __________________________________________________________________________________________
Page 1 of 9 3M(TM) Electronic Equipment Wipes #CL610 and 3M(TM) Notebook Screen Cleaning Wipes #CL630 01/22/15 Hazard Statements Flammable liquid and vapor.
Causes serious eye irritation.
Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
Ground/bond container and receiving equipment.
Use only non-sparking tools.
Take precautionary measures against static discharge.
Keep container tightly closed.
Use explosion-proof electrical/ventilating/lighting equipment.
Wear protective gloves and eye/face protection.
Wash thoroughly after handling.
IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do.
If eye irritation persists: Get medical advice/attention.
In case of fire: Use a fire fighting agent suitable for flammable liquids such as dry chemical or carbon dioxide to extinguish.
Store in a well-ventilated place. Keep cool.
Dispose of contents/container in accordance with applicable local/regional/national/international regulations.
2.3. Hazards not otherwise classified None.
*The specific chemical identity and/or exact percentage (concentration) of this composition has been withheld as a trade secret.
SECTION 4: First aid measures
4.1. Description of first aid measures
Remove person to fresh air. If you feel unwell, get medical attention.
Immediately wash with soap and water. Remove contaminated clothing and wash before reuse. If signs/symptoms develop, get medical attention.
Immediately flush with large amounts of water. Remove contact lenses if easy to do. Continue rinsing. Get medical attention.
Rinse mouth. If you feel unwell, get medical attention.
4.2. Most important symptoms and effects, both acute and delayed See Section 11.1. Information on toxicological effects.
4.3. Indication of any immediate medical attention and special treatment required Not applicable SECTION 5: Fire-fighting measures
5.1. Suitable extinguishing media In case of fire: Use a fire fighting agent suitable for flammable liquids such as dry chemical or carbon dioxide to extinguish.
5.2. Special hazards arising from the substance or mixture Closed containers exposed to heat from fire may build pressure and explode.
5.3. Special protective actions for fire-fighters Water may not effectively extinguish fire; however, it should be used to keep fire-exposed containers and surfaces cool and prevent explosive rupture.
SECTION 6: Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures Evacuate area. Keep away from heat/sparks/open flames/hot surfaces. - No smoking. Use only non-sparking tools.
Ventilate the area with fresh air. For large spill, or spills in confined spaces, provide mechanical ventilation to disperse or exhaust vapors, in accordance with good industrial hygiene practice. Warning! A motor could be an ignition source and could cause flammable gases or vapors in the spill area to burn or explode. Refer to other sections of this SDS for information regarding physical and health hazards, respiratory protection, ventilation, and personal protective equipment.
6.2. Environmental precautionsAvoid release to the environment.
6.3. Methods and material for containment and cleaning up Working from around the edges of the spill inward, cover with bentonite, vermiculite, or commercially available inorganic absorbent material. Mix in sufficient absorbent until it appears dry. Remember, adding an absorbent material does not remove a physical, health, or environmental hazard. Collect as much of the spilled material as possible using non-sparking tools. Place in a metal container approved for transportation by appropriate authorities. Clean up residue with water. Seal the container. Dispose of collected material as soon as possible.
SECTION 7: Handling and storage
7.1. Precautions for safe handling Avoid eye contact. Keep out of reach of children. Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
Use only non-sparking tools. Take precautionary measures against static discharge. Avoid breathing dust/fume/gas/mist/vapors/spray. Do not eat, drink or smoke when using this product. Wash thoroughly after handling.
Avoid contact with oxidizing agents (eg. chlorine, chromic acid etc.) Wear low static or properly grounded shoes. To minimize the risk of ignition, determine applicable electrical classifications for the process using this product and select specific local exhaust ventilation equipment to avoid flammable vapor accumulation.
7.2. Conditions for safe storage including any incompatibilities Store in a well-ventilated place. Keep cool. Keep container tightly closed. Protect from sunlight. Store away from heat.
Store away from acids. Store away from oxidizing agents.
SECTION 8: Exposure controls/personal protection
8.1. Control parameters
8.2. Exposure controls 8.2.1. Engineering controls Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure Limits and/or control dust/fume/gas/mist/vapors/spray. If ventilation is not adequate, use respiratory protection equipment.
Use explosion-proof ventilation equipment.
8.2.2. Personal protective equipment (PPE) Eye/face protection Select and use eye/face protection to prevent contact based on the results of an exposure assessment. The following eye/face
protection(s) are recommended:
Indirect Vented Goggles Skin/hand protection Select and use gloves and/or protective clothing approved to relevant local standards to prevent skin contact based on the results of an exposure assessment. Selection should be based on use factors such as exposure levels, concentration of the substance or mixture, frequency and duration, physical challenges such as temperature extremes, and other use conditions.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible gloves/protective clothing.
Gloves made from the following material(s) are recommended: Nitrile Rubber Respiratory protection An exposure assessment may be needed to decide if a respirator is required. If a respirator is needed, use respirators as part of a full respiratory protection program. Based on the results of the exposure assessment, select from the following respirator
type(s) to reduce inhalation exposure:
Half facepiece or full facepiece air-purifying respirator suitable for organic vapors For questions about suitability for a specific application, consult with your respirator manufacturer.
SECTION 10: Stability and reactivity
10.1. Reactivity This material may be reactive with certain agents under certain conditions - see the remaining headings in this section.
10.2. Chemical stability Stable.
10.3. Possibility of hazardous reactions Hazardous polymerization will not occur.
10.4. Conditions to avoid Sparks and/or flames
10.5. Incompatible materials Not determined
The information below may not be consistent with the material classification in Section 2 if specific ingredient classifications are mandated by a competent authority. In addition, toxicological data on ingredients may not be reflected in the material classification and/or the signs and symptoms of exposure, because an ingredient may be present below the threshold for labeling, an ingredient may not be available for exposure, or the data may not be relevant to the material as a whole.
11.1. Information on Toxicological effects Signs and Symptoms of Exposure
Based on test data and/or information on the components, this material may produce the following health effects:
Respiratory Tract Irritation: Signs/symptoms may include cough, sneezing, nasal discharge, headache, hoarseness, and nose and throat pain.
Dermal Defatting: Signs/symptoms may include localized redness, itching, drying and cracking of skin.
Severe Eye Irritation: Signs/symptoms may include significant redness, swelling, pain, tearing, cloudy appearance of the cornea, and impaired vision.
Physical Blockage: Signs/symptoms may include cramping, abdominal pain, and constipation.
Gastrointestinal Irritation: Signs/symptoms may include abdominal pain, stomach upset, nausea, vomiting and diarrhea.
Toxicological Data If a component is disclosed in section 3 but does not appear in a table below, either no data are available for that endpoint or the data are not sufficient for classification.
Aspiration Hazard For the component/components, either no data are currently available or the data are not sufficient for classification.
Please contact the address or phone number listed on the first page of the SDS for additional toxicological information on this material and/or its components.
SECTION 12: Ecological information Ecotoxicological information Please contact the address or phone number listed on the first page of the SDS for additional ecotoxicological information on this material and/or its components.
Chemical fate information Please contact the address or phone number listed on the first page of the SDS for additional chemical fate information on this material and/or its components.
SECTION 13: Disposal considerations
13.1. Disposal methods Dispose of contents/ container in accordance with the local/regional/national/international regulations.